muc-off kit tubeless setup ULTIMATE XC/gravel

Sale priceRs. 4,300.00



The Muc-Off Ultimate Tubeless Kit contains everything needed to get a tubeless-ready wheelset set up and ready to roll.

  • Ideal for rim widths of 23 - 25mm
  • Suitable for XC / Trail Bikes (Comes with 44mm tubeless valves and 25mmx10m Rim Tape).


Each Kit contains
  • Tubeless Rim Tape,
  • Two CNC-machined black tubeless valves,
  • Two pouches of No Puncture Hassle Tubeless Sealant.


How to Use
  1. Remove all old rim strips or tape and clean the rim.
  2. Make sure the rim is clean and dry before applying the tape.
  3. Get the tape from the packet and line it up from the opposite side of the valve.
  4. Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold the pressure down.
  5. Continue to hold while you pull back on the tape and stick down tight. Once you have a few cm on, the video will stick, and holding is no longer needed.
  6. Continue the entire way around the rim (if it has a big concave, you can pull and wiggle the tape to fill any edges)
  7. Overlap the tape by roughly 10 – 15cm
  8. Leave a small amount unstuck so that you can cut the remainder off
  9. Once cut, sketch and pull the tape down to create a seal
  10. Go around the rim with your thumb to ensure no air pockets or messed areas.
  11. Once you are happy with how it looks, using a small pin, locate the valve hole and cleanly pierce the tape ready for the valve
  12. Grab your tubeless valve and remove the lock ring and o ring
  13. Chose the proper rubber fitment for your rim tape and inserted the valve into the rim
  14. Refit O-ring and Lockring making sure you lock the valve in (don’t go too tight, or could damage the rubber)
  15. Refit your tire of choice, careful not to damage the tape (by using tire levers, etc.)
  16. Inflate the tire to create a fit (you should hear some popping around the rim)
  17. Release Air and remove the valve core using the spare valve cap
  18. Grab the sealant pouch and give it a shake
  19. Unscrew the cap and fit on the valve in an upright position
  20. While holding the pouch, spin the wheel down so that the bag is now upside down
  21. Insert the sealant by rolling the bag down
  22. Spin the wheel back upright and remove the pouch
  23. Reinsert the valve core and inflate to your pressure.

Everything Needed to Get Set up And Ready to Roll
Our Ultimate Tubeless Setup Kit is a one-stop shop for everything you need to make the switch with your tubeless-ready wheelset.


A Wide Range of Sizes Is Available
Various Kits are available for road, gravel, and CX to enduro, trail, and downhill. This kit is for XC / Trail (44mm tubeless valves and 25mmx10m Rim Tape).


You may also like

Recently viewed